159 lines
6.7 KiB
C
159 lines
6.7 KiB
C
/* Generic NS8390 register definitions. */
|
|
/* This file is part of Donald Becker's 8390 drivers, and is distributed
|
|
under the same license.
|
|
Some of these names and comments originated from the Crynwr
|
|
packet drivers, which are distributed under the GPL. */
|
|
|
|
#ifndef _8390_h
|
|
#define _8390_h
|
|
|
|
#include <linux/if_ether.h>
|
|
#include <linux/ioport.h>
|
|
|
|
#define TX_2X_PAGES 12
|
|
#define TX_1X_PAGES 6
|
|
#define TX_PAGES (ei_status.pingpong ? TX_2X_PAGES : TX_1X_PAGES)
|
|
|
|
#define ETHER_ADDR_LEN 6
|
|
|
|
/* From 8390.c */
|
|
extern int ei_debug;
|
|
extern struct sigaction ei_sigaction;
|
|
|
|
extern int ethif_init(struct device *dev);
|
|
extern int ethdev_init(struct device *dev);
|
|
extern void NS8390_init(struct device *dev, int startp);
|
|
extern int ei_open(struct device *dev);
|
|
extern void ei_interrupt(int reg_ptr);
|
|
|
|
#ifndef HAVE_AUTOIRQ
|
|
/* From auto_irq.c */
|
|
extern struct device *irq2dev_map[16];
|
|
extern void autoirq_setup(int waittime);
|
|
extern int autoirq_report(int waittime);
|
|
#endif
|
|
|
|
/* Most of these entries should be in 'struct device' (or most of the
|
|
things in there should be here!) */
|
|
/* You have one of these per-board */
|
|
struct ei_device {
|
|
char *name;
|
|
void (*reset_8390)(struct device *);
|
|
void (*block_output)(struct device *, int, const unsigned char *, int);
|
|
int (*block_input)(struct device *, int, char *, int);
|
|
int open:1;
|
|
int word16:1; /* We have the 16-bit (vs 8-bit) version of the card. */
|
|
int txing:1; /* Transmit Active */
|
|
int dmaing:2; /* Remote DMA Active */
|
|
int irqlock:1; /* 8390's intrs disabled when '1'. */
|
|
int pingpong:1; /* Using the ping-pong driver */
|
|
unsigned char tx_start_page, rx_start_page, stop_page;
|
|
unsigned char current_page; /* Read pointer in buffer */
|
|
unsigned char interface_num; /* Net port (AUI, 10bT.) to use. */
|
|
unsigned char txqueue; /* Tx Packet buffer queue length. */
|
|
unsigned char in_interrupt;
|
|
short tx1, tx2; /* Packet lengths for ping-pong tx. */
|
|
short lasttx; /* Alpha version consistency check. */
|
|
unsigned char reg0; /* Register '0' in a WD8013 */
|
|
unsigned char reg5; /* Register '5' in a WD8013 */
|
|
unsigned char saved_irq; /* Original dev->irq value. */
|
|
/* The new statistics table. */
|
|
struct enet_statistics stat;
|
|
};
|
|
|
|
#define ei_status (*(struct ei_device *)(dev->priv))
|
|
|
|
/* Some generic ethernet register configurations. */
|
|
#define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */
|
|
#define E8390_RX_IRQ_MASK 0x5
|
|
#define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */
|
|
#define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */
|
|
#define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */
|
|
#define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */
|
|
|
|
/* Register accessed at EN_CMD, the 8390 base addr. */
|
|
#define E8390_STOP 0x01 /* Stop and reset the chip */
|
|
#define E8390_START 0x02 /* Start the chip, clear reset */
|
|
#define E8390_TRANS 0x04 /* Transmit a frame */
|
|
#define E8390_RREAD 0x08 /* Remote read */
|
|
#define E8390_RWRITE 0x10 /* Remote write */
|
|
#define E8390_NODMA 0x20 /* Remote DMA */
|
|
#define E8390_PAGE0 0x00 /* Select page chip registers */
|
|
#define E8390_PAGE1 0x40 /* using the two high-order bits */
|
|
#define E8390_PAGE2 0x80 /* Page 3 is invalid. */
|
|
|
|
#define E8390_CMD 0x00 /* The command register (for all pages) */
|
|
/* Page 0 register offsets. */
|
|
#define EN0_CLDALO 0x01 /* Low byte of current local dma addr RD */
|
|
#define EN0_STARTPG 0x01 /* Starting page of ring bfr WR */
|
|
#define EN0_CLDAHI 0x02 /* High byte of current local dma addr RD */
|
|
#define EN0_STOPPG 0x02 /* Ending page +1 of ring bfr WR */
|
|
#define EN0_BOUNDARY 0x03 /* Boundary page of ring bfr RD WR */
|
|
#define EN0_TSR 0x04 /* Transmit status reg RD */
|
|
#define EN0_TPSR 0x04 /* Transmit starting page WR */
|
|
#define EN0_NCR 0x05 /* Number of collision reg RD */
|
|
#define EN0_TCNTLO 0x05 /* Low byte of tx byte count WR */
|
|
#define EN0_FIFO 0x06 /* FIFO RD */
|
|
#define EN0_TCNTHI 0x06 /* High byte of tx byte count WR */
|
|
#define EN0_ISR 0x07 /* Interrupt status reg RD WR */
|
|
#define EN0_CRDALO 0x08 /* low byte of current remote dma address RD */
|
|
#define EN0_RSARLO 0x08 /* Remote start address reg 0 */
|
|
#define EN0_CRDAHI 0x09 /* high byte, current remote dma address RD */
|
|
#define EN0_RSARHI 0x09 /* Remote start address reg 1 */
|
|
#define EN0_RCNTLO 0x0a /* Remote byte count reg WR */
|
|
#define EN0_RCNTHI 0x0b /* Remote byte count reg WR */
|
|
#define EN0_RSR 0x0c /* rx status reg RD */
|
|
#define EN0_RXCR 0x0c /* RX configuration reg WR */
|
|
#define EN0_TXCR 0x0d /* TX configuration reg WR */
|
|
#define EN0_COUNTER0 0x0d /* Rcv alignment error counter RD */
|
|
#define EN0_DCFG 0x0e /* Data configuration reg WR */
|
|
#define EN0_COUNTER1 0x0e /* Rcv CRC error counter RD */
|
|
#define EN0_IMR 0x0f /* Interrupt mask reg WR */
|
|
#define EN0_COUNTER2 0x0f /* Rcv missed frame error counter RD */
|
|
|
|
/* Bits in EN0_ISR - Interrupt status register */
|
|
#define ENISR_RX 0x01 /* Receiver, no error */
|
|
#define ENISR_TX 0x02 /* Transmitter, no error */
|
|
#define ENISR_RX_ERR 0x04 /* Receiver, with error */
|
|
#define ENISR_TX_ERR 0x08 /* Transmitter, with error */
|
|
#define ENISR_OVER 0x10 /* Receiver overwrote the ring */
|
|
#define ENISR_COUNTERS 0x20 /* Counters need emptying */
|
|
#define ENISR_RDC 0x40 /* remote dma complete */
|
|
#define ENISR_RESET 0x80 /* Reset completed */
|
|
#define ENISR_ALL 0x3f /* Interrupts we will enable */
|
|
|
|
/* Bits in EN0_DCFG - Data config register */
|
|
#define ENDCFG_WTS 0x01 /* word transfer mode selection */
|
|
|
|
/* Page 1 register offsets. */
|
|
#define EN1_PHYS 0x01 /* This board's physical enet addr RD WR */
|
|
#define EN1_CURPAG 0x07 /* Current memory page RD WR */
|
|
#define EN1_MULT 0x08 /* Multicast filter mask array (8 bytes) RD WR */
|
|
|
|
/* Bits in received packet status byte and EN0_RSR*/
|
|
#define ENRSR_RXOK 0x01 /* Received a good packet */
|
|
#define ENRSR_CRC 0x02 /* CRC error */
|
|
#define ENRSR_FAE 0x04 /* frame alignment error */
|
|
#define ENRSR_FO 0x08 /* FIFO overrun */
|
|
#define ENRSR_MPA 0x10 /* missed pkt */
|
|
#define ENRSR_PHY 0x20 /* physical/multicase address */
|
|
#define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */
|
|
#define ENRSR_DEF 0x80 /* deferring */
|
|
|
|
/* Transmitted packet status, EN0_TSR. */
|
|
#define ENTSR_PTX 0x01 /* Packet transmitted without error */
|
|
#define ENTSR_ND 0x02 /* The transmit wasn't deferred. */
|
|
#define ENTSR_COL 0x04 /* The transmit collided at least once. */
|
|
#define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */
|
|
#define ENTSR_CRS 0x10 /* The carrier sense was lost. */
|
|
#define ENTSR_FU 0x20 /* A "FIFO underrun" occured during transmit. */
|
|
#define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */
|
|
#define ENTSR_OWC 0x80 /* There was an out-of-window collision. */
|
|
|
|
/* The per-packet-header format. */
|
|
struct e8390_pkt_hdr {
|
|
unsigned char status; /* status */
|
|
unsigned char next; /* pointer to next packet. */
|
|
unsigned short count; /* header + packet lenght in bytes */
|
|
};
|
|
#endif /* _8390_h */
|